Connecting Your Monitor ProLite B1902S

CONNECTING YOUR MONITOR : ProLite B1902S

AEnsure that both the computer and the monitor are switched off.

BConnect the computer to the monitor with the signal cable. (See page 34 for CONNECTOR PIN ASSIGNMENT.)

CConnect the monitor to the audio equipment with the Audio Cable when using the audio features.

DConnect the Power Cable to the monitor first and then to the power supply.

NOTE The signal cables used for connecting the computer and monitor may vary with the type of computer used. An incorrect connection may cause serious damage to both the monitor and the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a special cable is required please contact your local iiyama dealer or regional iiyama office. For connection to Macintosh computers, contact your local iiyama dealer or regional iiyama office for a suitable adaptor.

Make sure you tighten the finger screws at each end of the signal cable.

[Example of Connection]

<Back>

ENGLISH

D-Sub Signal Cable

Power Cable(Accessory)

(Accessory)

DVI-D Signal Cable (Accessory)

Audio Cable (Accessory)	Computer

[ Fitting of Cable Holder ]

A Collect cables at the back of the stand.

B Inserting the tabs of the Cable Holder into guide holes of the stand.(B)

C Place the Cable Holder by inserting the tabs of the Cable Holder into guide holes of the stand.(C)

[ Removal of Cable Holder ]

A Push the both sides and tilt back the Cable

Holder.

BEFORE YOU OPERATE THE MONITOR 10