Iiyama B1906S user manual Connecting Your Monitor ProLite E1906S

CONNECTING YOUR MONITOR : ProLite E1906S

AEnsure that both the computer and the monitor are switched off.

BConnect the computer to the monitor with the signal cable.

CConnect the monitor to the audio equipment with the Audio Cable for computer when using the audio features.

DConnect the Power Cable to the monitor first and then to the power supply.

EPower of the monitor and the computer is turned on.

NOTE  The signal cables used for connecting the computer and monitor may vary with the type of computer used. An incorrect connection may cause serious damage to both the monitor and the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a special cable is required please contact your local iiyama dealer or regional iiyama office.

For connection to Macintosh computers, contact your local iiyama dealer or regional iiyama office for a suitable adaptor.

Make sure you tighten the finger screws at each end of the signal cable.

[Example of Connection]

<Back>

ENGLISH

Power Cable	D-Sub Signal Cable
(Accessory)	(Accessory)
	DVI-D Signal Cable
	(Accessory)
	Audio Cable (Accessory)

Computer

BEFORE YOU OPERATE THE MONITOR 10