COMPUTER SETTING
Signal Timing
Change to the desired signal timings listed on page 21 in COMPLIANT TIMING.
Windows 95/98/2000/Me/XP/Vista Plug & Play
The iiyama LCD monitor complies with DDC2B of VESA standard. The Plug & Play function runs on Windows 95/98/2000/Me/XP/Vista by connecting the monitor to DDC2B compliant computer with the Signal Cable supplied. Windows 95/98/2000/Me/XP Monitor Information File for iiyama monitors may be necessary for your computer and obtained via the Internet, using the address:
http://www.iiyama.com
NOTE | For additional information on how to download the driver for your monitor, please |
| access one of the internet sites noted above. |
Monitor Drivers are not required in most cases for Macintosh or Unix operating systems. For further information, please contact your computer dealer first for advice.
Procedure for turning ON the Power Switch Turn ON the monitor first, and then the computer.
Touch screen driver software
Touch screen driver software and system may not start when you start your computer while touching the screen.
Touch screen driver software may not run due to the power saving function depending on the BIOS of your computer. In this case, set the power saving function to off.
ENGLISH
ADJUSTING THE VIEWING ANGLE
For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to your own preference.
Hold the panel so that the monitor does not topple |
| |
when you change the monitor’s angle. |
| |
You are able to adjust the monitor’s angle up to 90 |
| |
degrees upward, 5 degrees downward. |
| |
NOTE | Do not touch the LCD screen when you | 90˚ |
| ||
| change the angle. It may cause damage |
|
| or break the LCD screen. |
|
Careful attention is required not to catch
your fingers or hands when you change | 5˚ |
the angle. |
|
BEFORE YOU OPERATE THE MONITOR 8