HandHeld Entertainment Quick Check 890 manual USB Communication Interface, USB COM Port Emulation

Page 10

USB Communication Interface

For the USB interface, the Hand Held Products CDC-ACM driver must be installed prior to using the QC890 Verifier. This driver is copied to the following directory during install:

<install location>\Drivers\USBCOMPortEmulation/hhpcdc.inf

The default <install location> is C:\Program Files\Hand Held Products\Quick Check ImageData\drivers\USBCOMPortEmulation.

!Review the file, readme.rtf, in the install location prior to running the QCID.

Connect the QC890 Verifier to the host as shown in the illustration below.

1

2

USB COM Port Emulation

Scan the following barcode to program the QC890 Verifier to emulate an RS- 232-based COM Port. After connecting the QC890 Verifier and upon successful installation of the USB driver, the driver will use the next available COM Port. USB COM Port Emulation is the default interface for the QC890 Verifier.

* USB COM Port Emulation

Note: No additional configuration (e.g., baud rate) is necessary.

2 - 2

Quick Check® 890 User’s Guide

Image 10

Contents Quick Check Quick Check ImageData Disclaimer Table of Contents Maintenance Introduction QC890 Verifier FeaturesGetting Started Unpacking the QC890 VerifierScan Button Using the QC890 VerifierScan Button LEDs User LED Indications Special FeaturesPhysical Connections Audio SoundCharging the Battery SpecificationsInternal Battery Powering On the QC890 VerifierQuick Check ImageData Installation of Quick Check ImageDataQuick Check ImageData System RequirementsUSB Communication Interface USB COM Port EmulationRS-232 Serial Communication Interface BluetoothRS-232 Selections Using the QC890 Verifier with Bluetooth Devices Enabling Your Device for Bluetooth Enabling Qcid for Bluetooth Using Quick Check ImageData Help System Scanning a Barcode Symbol Using the QC890 Verifier Using the Quick Check 890 Verifier SystemScanning a Barcode Symbol Using Quick Check ImageData Calibrating the QC890 Verifier Scanning Properly Using a Pen/Mouse Wand Calibrating an External Pen/Mouse Wand Scanning Properly Using the QC3800VE Linear Imager Reflectometer Mode Calibration LogQuick Check 890 User’s Guide Quick Check 890 User’s Guide QC890 Verifier MaintenanceCleaning the External Devices RecertificationQuick Check 890 User’s Guide Customer Support Technical AssistanceProduct Service and Repair Online Technical Assistance For Further InformationLimited Warranty Online Product Service and Repair AssistanceQuick Check 890 User’s Guide Apertures Pen/Mouse Wand Aperture SelectionQuick Check 890 User’s Guide Resetting the Standard Product Defaults Menu Setting BarcodesIllumination Timer Power Down Timer Symbology Defaults Operation Quick Check 890 User’s Guide Page Page Page Hand Held Products, Inc