HandHeld Entertainment Quick Check 890 manual Using the QC890 Verifier, Scan Button LEDs

Page 6

The verifier tests the following symbologies:

Codabar

Micro PDF417

Code 11

MSI

Code 16K

PDF417

Code 39

Reduced Space Symbology (RSS-14, RSS

 

Limited, RSS Expanded)

Code 49

Regular 2 of 5

Code 93

Straight 2 of 5 IATA

Code 128

Telepen

Interleaved 2 of 5

UPC/EAN

Using the QC890 Verifier

The QC890 Verifier offers a choice of Automatic, 3, 5, 6, and 10 mil aperture settings. External devices (i.e., mouse wands, pen wands, and linear imagers) are available with apertures designed to match the most common X dimensions. Wands are available with apertures of 3 (Mouse Wand only), 5, 6, 10, and 20 (Mouse Wand only) mil. These aperture sizes correspond to those specified in ISO/IEC 15416 Barcode Print Quality Test Specification - Linear Symbols. The proper aperture should be selected based on the X dimension range shown in the table in the Pen/Mouse Wand Aperture Selection (page A-1)section.

Choosing an inappropriate scanning aperture results in inaccurate quality measures. Too small an aperture may detect reflectance non-uniformities (spots and voids) that would not affect scanning with a "normal" aperture size. Too large an aperture will not be able to resolve individual elements of the symbol.

Scan Button

The scan button on top of the unit wakes the unit from power down. A first press of the button turns on illumination and a second press activates reading capabilities.

Scan Button LEDs

•Red LED - error conditions

•Green LED - good symbols and configuration changes

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Quick Check Quick Check ImageData Disclaimer Table of Contents Maintenance Introduction QC890 Verifier FeaturesGetting Started Unpacking the QC890 VerifierUsing the QC890 Verifier Scan ButtonScan Button LEDs User LED Indications Special FeaturesPhysical Connections Audio SoundCharging the Battery SpecificationsInternal Battery Powering On the QC890 VerifierQuick Check ImageData Installation of Quick Check ImageDataQuick Check ImageData System RequirementsUSB Communication Interface USB COM Port EmulationBluetooth RS-232 Serial Communication InterfaceRS-232 Selections Using the QC890 Verifier with Bluetooth Devices Enabling Your Device for Bluetooth Enabling Qcid for Bluetooth Using Quick Check ImageData Help System Using the Quick Check 890 Verifier System Scanning a Barcode Symbol Using the QC890 VerifierScanning a Barcode Symbol Using Quick Check ImageData Calibrating the QC890 Verifier Scanning Properly Using a Pen/Mouse Wand Calibrating an External Pen/Mouse Wand Scanning Properly Using the QC3800VE Linear Imager Reflectometer Mode Calibration LogQuick Check 890 User’s Guide Quick Check 890 User’s Guide QC890 Verifier MaintenanceCleaning the External Devices RecertificationQuick Check 890 User’s Guide Customer Support Technical AssistanceProduct Service and Repair Online Technical Assistance For Further InformationLimited Warranty Online Product Service and Repair AssistanceQuick Check 890 User’s Guide Apertures Pen/Mouse Wand Aperture SelectionQuick Check 890 User’s Guide Menu Setting Barcodes Resetting the Standard Product DefaultsIllumination Timer Power Down Timer Symbology Defaults Operation Quick Check 890 User’s Guide Page Page Page Hand Held Products, Inc
Top Page Image Contents