Envision Peripherals EN-8100E Adjusting the Viewing Angle, How to Install INF & ICM File

Page 10

Before You Operate the Monitor EN-8100e

Adjusting the Viewing Angle

For optimal viewing, adjust the monitor's angle to your own preference.

•Hold the stand firmly when you change the monitor's angle.

•You can adjust the monitor's angle from -5° to 30°.

•Do not touch the LCD screen when you change the angle. It may cause damage or breakage.

•Be careful to avoid pinching your hand in the swivel base.

How to Install INF & ICM File

1.Insert the Windows 95/98/2000/ME/XP INF Driver Disk into your floppy drive.

2.Follow the Add New Hardware Wizard instructions on the screen.

3.If the wizard asks for the location of the driver file, select drive A and press Next.

EN-8100e	10	v1_081502

Image 10

Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautionsEN-8100e Special Notes on LCD Monitors Using the Right Power CordGeneral Notes Package Contents Installing & Removing the Base General FeaturesBefore You Operate the Monitor EN-8100e Connecting the Wires Using the Power Cord Supplied Before You Operate the Monitor EN-8100e Before You Operate the Monitor EN-8100e Install An Optional Wall Mounting Arm Not supplied Adjusting the Viewing Angle How to Install INF & ICM FileOperating Instructions EN-8100e Front Panel ButtonsAdjusting the OSD Settings Operating InstructionsPlug & Play DDC1/2B Feature How to Optimize the DOS-modeDOS-mode Technical Support FAQ Problem Possible SolutionError Message Possible Solution Technical Support FAQ Resolution Vertical Pixels FrequencySpecifications AppendixEN-8100eOptimal Viewing Mode 1280 x 1024 x 60 Hz AppendixFactory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number DescriptionLimited 3-Year Warranty Warranty