Envision Peripherals EN-8100E user manual Connecting the Wires Using the Power Cord Supplied

Page 6

Before You Operate the Monitor EN-8100e

Connecting the Wires Using the Power Cord Supplied

1.Connect the built-in video cable into the 15-pin connector on the back of your computer and tighten the two screws.

2.Connect the power cord into the power adaptor.

3.Plug the other end of the power cord into a grounded AC outlet or UL-approved power strip.

4.Connect the power adaptor into the DC IN socket on the back of the monitor.

Caution: Make sure the power cord is the correct type that is required in your area. This LCD monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage areas (no user adjustment is required).

If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied).

EN-8100e

6

v1_081502

Image 6

Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautionsEN-8100e Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Installing & Removing the Base General Features Package ContentsBefore You Operate the Monitor EN-8100e Connecting the Wires Using the Power Cord Supplied Before You Operate the Monitor EN-8100e Before You Operate the Monitor EN-8100e Install An Optional Wall Mounting Arm Not supplied Adjusting the Viewing Angle How to Install INF & ICM FileOperating Instructions EN-8100e Front Panel ButtonsAdjusting the OSD Settings Operating InstructionsHow to Optimize the DOS-mode Plug & Play DDC1/2B FeatureDOS-mode Technical Support FAQ Problem Possible SolutionError Message Possible Solution Technical Support FAQ Resolution Vertical Pixels FrequencySpecifications AppendixEN-8100eOptimal Viewing Mode 1280 x 1024 x 60 Hz AppendixFactory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number DescriptionLimited 3-Year Warranty Warranty