Monessen Hearth NB18, NB24 Log Placement, Placing Rock Wool, Use only rock wool

Models: NB18 NB24

1 40
Download 40 pages 3.07 Kb
Page 23
Image 23
LOG PLACEMENT

LOG PLACEMENT

Before you begin — This unit is supplied with seven (7) ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.

WARNINGPLACING ROCK WOOLrock wool.• Use only rock wool

The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater. Only use the logs and 2G-RW rock wool (for NB18), or 3G-RW rock wool (for NB24) supplied with the unit.

Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal injury.

PLACING ROCK WOOL

Before installing logs, place rockwool in dime size pieces evenly over small burner ports starting in the rear of the burner going towards the front. Avoid placing rock wool on slots on each side of rear burner and on large yellow flame ports on front of burner.

Wash hands after placing rock wool. Itching may occur.

 

WARNING

 

rock wool.

 

 

 

• Use only rock wool

 

 

 

provided with log set.

 

 

 

• Do not add additional

 

 

 

 

Dime-Size

Rock Wool

Figure 19 - Placing Rock Wool

NOTE: Installation instructions are the

same for 18", 24", and 30" log sets. Pictures used in this manual illustrate the 24" set. Some variation may exist between the images and the set included with this manual.

INSTALLING 18", 24" AND 30" (F,R) BERKLEY OAK LOGS ON NATURAL BLAZE BURNER

1.Place the #1 log (the “chunk”) on the grate bar right side of the burner adjacent to the controls. See Figure 20

2.Place front right log (#2) on right pin located on burner and right grate bar. Then, slide the #1 log foward so that it is tight against the #2 log. See Figure 21

3.Place right rear log (#3) on pin located on rear support bracket and rest left side of log on front right log. See Figure

22

#1

#2

 

Figure 20 - Placing Log #1

Figure 21 - Placing Log #2

81D0107

23

Page 23
Image 23
Monessen Hearth NB18, NB24 Log Placement, Placing Rock Wool, Use only rock wool, provided with log set