Envision Peripherals G2219 manual Controls and Connectors Signal Cable, Sub

Page 7

CONTROLS AND CONNECTORS

SIGNAL CABLE

Connecting the Signal Cable: Plug the Signal Cable one end to LCD monitor’s “DSUB-Input” socket, the other end to the computer's VGA port and tighten the two screws on the cable connector.

Connecting the Power Cord: Plug the AC-power cord into the External Adapter. Then plug the DC-jack power cable into DC-IN Inlet.

Connecting the DVI Cable: Connect one end of the 24-pin DVI cable to the back of the monitor and connect the other end to the computer’s DVI port.

Caution: If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied).

		Figure 2 Connecting Cables

1.	Power	input socket
2	DVI input socket
3.	D-SUB	input socket

6

Image 7

Contents Page Table of Contents FCC Class B Radio Frequency Interference Statement Precautions Checking the Contents of the Package FeaturesSpecial Notes on LCD Monitors Power Cord Installation Instructions Swivel BasePower Source SUB Controls and Connectors Signal CableAdjusting the Viewing Angle +/DCR General InstructionsExternal Controls SourceAuto Adjust button / Exit Power IndicatorFront Panel Control OSD Message HOW to Adjust a SettingMain Sub Menu Description Menu Item Icon Adjusting the PictureClock Adjust Picture Clock Reduce Vertical-Line noise Full On or off Disable or Enable Full Enhance DDC/CI Plug and PlayOSD DVIPlug & Play DDC2B Feature Blue Technical Support FAQPage Input not Support Error Message & Possible Solution No SignalTTL SpecificationsVesa DDC2BTM CCC MenuFactory Preset Timing Table PIN no Description Connector PIN AssignmentISO 14001 Certification