Dell W- AP92, W-AP105, AP-92 5 AP-175 TEL Placement, Aruba AP-105 Tel placement bottom view

Page 23

Figure 19 - Aruba AP-105 Tel placement bottom view

3.2.5 AP-175 TEL Placement

This section displays all the TEL locations of the Aruba AP-175. The AP-175 requires a minimum of 6 TELs to be applied as follows:

3.2.5.1To detect access to restricted ports:

1.Spanning the USB console port

2.Spanning the power connector plug (AP-175P only)

3.Spanning the hex screw

3.2.5.2To detect opening of the chassis cover:

4.Spanning the top and bottom chassis covers on the left side

5.Spanning the top and bottom chassis covers on the right side

Following is the TEL placement for the AP-175:

Figure 19 - Aruba AP-175 Tel placement front view

23

Image 23

Contents Version Feb Aruba Networks Crossman Ave Sunnyvale, CA Page Security Levels Physical Security Aruba Dell Relationship Acronyms and AbbreviationsAP-105 Series AP-175 SeriesROLES, Authentication and Services Acronyms and Abbreviations IntroductionAruba Dell Relationship IPSec GHzAruba Part Number Dell Corresponding Part Number Product OverviewAP-92 Physical DescriptionEnet AP-92 Indicator LEDs Label Function Action StatusPWR Label Function Action Status AP-93AP-93 Indicator LEDs Label Function Action Status AP-105 Series AP-105 Wireless Access PointAP-105 Indicator LEDs Label Function Action Status AP-175 Series AP-175 Wireless Access PointPhysical Description Function Action Status Position AP-175 Indicator LEDs LabelApplying TELs Module ObjectivesSecurity Levels Physical SecurityAP-92 Tel placement front view 2 AP-92 TEL PlacementAruba AP-92 Tel placement right view Aruba AP-92 Tel placement bottom view 3 AP-93 TEL PlacementAruba AP-93 Tel placement left view Aruba AP-93 Tel placement top view 4 AP-105 TEL PlacementAruba AP-105 Tel placement left view Aruba AP-105 Tel placement bottom view 5 AP-175 TEL PlacementAruba AP-175 Tel placement back view Aruba AP-175 Tel placement top view Inspection/Testing of Physical Security MechanismsModes of Operation Configuring Remote AP Fips ModeEnable Fips mode on the AP. This accomplished by going to Configuring Remote Mesh Portal Fips Mode Configuring Remote Mesh Point Fips Mode Operational Environment Verify that the module is in Fips modeFips 140-2 Logical Interfaces Module Physical Interface Logical InterfacesRoles Roles, Authentication and ServicesCrypto Officer Authentication Authentication Mechanism Strength User AuthenticationWireless Client Authentication Strength of Authentication MechanismsWPA2-PSK KEK ServicesCrypto Officer Services WPA2 PSKEapol MIC User ServicesPMK PTKUnauthenticated Services Wireless Client Services∙ FTP ∙ Tftp ∙ NTP Non-FIPS Approved Algorithms Cryptographic AlgorithmsHmac Critical Security ParametersRNG AES-CCM PSKGTK GMKSelf Tests For an AES Atheros hardware Post failure