Dell C510, C610 manual Flashing the Bios

Page 39

Flashing the BIOS: Dell Latitude C610/C510 Service Manual

Back to Contents Page

Flashing the BIOS

Dell™ Latitude™ C610/C510 Service Manual

Flashing the BIOS

Flashing the BIOS

To update the basic input/output system (BIOS):

1.Make sure that the AC adapter is plugged in and that the main battery is installed properly.

2.Turn on the computer. The following error message appears:

System hardware failures: #0010 Strike the F1 key to shutdown

3.Instead of pressing <F1>, insert the flash BIOS update floppy disk or CD into the appropriate drive and press <F6>, and then press <F4>. The computer displays the following message on the screen:

Failure override

Processor update failure. Reload current BIOS

Strike the F1 key to continue, F2 to run the setup utility.

4.Press <F1>. The computer continues to boot and updates the new BIOS.

5.Press <F2> to enter the system setup program and reset the boot sequence with the appropriate drive, if required.

6.Press <ESC> to exit the system setup program.

7.Remove the flash BIOS update floppy disk or CD from the drive and restart the computer.

Back to Contents Page

file:///C/Work%20Area%20-%20A/E%20DOC%20Posting/latc610/service%20manual/bios.htm[2/1/2013 11:00:50 AM]

Image 39

Contents January 2002 Rev. A01 Before You Begin Preparing to Work Inside the ComputerRecommended Tools Back Right Front 4 left Screw IdentificationComputer Orientation Screw IdentificationHard Drive Door Keyboard to Each Display BezelBottom Case Each 1 each Each 3 each Back to Contents Keyboard Display assembly Bottom case Center control coverSystem Components Exploded ViewFan guard Bottom of computer M3 x 5-mm screw 3 hard drive door Hard DriveRemoving the Hard Drive Hard Drive RemovalReplacing the Hard Drive Memory Module Cover Memory Modules, Mini PCI Card, and ModemMemory Modules Removing the Memory Module CoverRemoving the Memory Modules Replacing the Memory ModulesMemory Module Removal Mini PCI Card Removing the Mini PCI CardMini PCI Card Removing the Modem Antenna connectors on card 2 2 antenna cablesModem Replacing the Mini PCI CardM2 x 3-mm screws Modem connector Modem cable 4 pull tab Replacing the ModemModem Removal Page Keyboard Removing the KeyboardScrew Removal Keyboard Removal Center Control Cover RemovalReplacing the Keyboard Keyboard Connector RemovalBack to Contents Display Assembly, Display Latch, and Hinge Covers Display AssemblyDisplay Assembly Remove the center control cover Display-Feed Flex Cable ConnectorRemoving the 14.1-Inch Display Bezel Inch Display Bezel and PanelTop cover Display panel Removing the 14.1-Inch Display Panel Display-Feed Flex Cable ConnectionsBatteries Remove the hard drive Replacing the 14.1-Inch Display Panel Display Latch Removal 14.1-Inch XGA Panel Shown Display LatchRemoving the Display Latch Replacing the Display LatchReplacing the Hinge Covers Hinge Cover ReplacementHinge Covers Removing the Hinge CoversRight hinge cover 2 left hinge cover Remove the hard drive Remove the keyboard Palm RestRemoving the Palm Rest Palm Rest Screw RemovalPalm Rest Removal Back to Contents Microprocessor thermal cooling assembly 2 captive screws Microprocessor Thermal Cooling AssemblyRemoving the Microprocessor Thermal Cooling Assembly Microprocessor Thermal Cooling Assembly RemovalReplacing the Microprocessor Thermal Cooling Assembly Microprocessor Module Removing the Microprocessor ModuleMicroprocessor Module Removal Replacing the Microprocessor Module Remove the microprocessor thermal cooling assemblyRemove the palm rest Hybrid Cooling FanRemoving the Hybrid Cooling Fan Hybrid Cooling Fan RemovalM2 x 3-mm screw Reserve battery Speaker connector Reserve BatteryRemoving the Reserve Battery Reserve Battery RemovalSystem board connector 4 reserve battery cable Replacing the Reserve BatteryFlashing the Bios Flashing the BiosSpeaker Assemblies Removing the Speaker AssembliesRouting the Left Speaker Cable Speaker Orientation Speaker Assemblies Antenna cable In-line connector Replacing the Speaker Assemblies System Board Removing the System BoardSystem Board Screw Removal M2.5 x -mm screw System Board RemovalReplacing the System Board Battery and Module Bay Latches Removing the Battery and Module Bay LatchesBattery and Module Bay Latches Replacing the Battery and Module Bay Latches Data Pin Assignments for I/O ConnectorsUSB Connector Serial ConnectorParallel Connector Video Connector18-23 Video TV-Out Connector PS/2 ConnectorDocking Connector 124 121122 123164 161162 163Back to Contents

Related manuals

Manual 138 pages 13.75 Kb