1 | screws (2) | 2 | media card reader |
3USB interface cable
4.Disconnect the USB cable from the back of the media card reader.
5.For the Vostro 420 and Vostro 220, remove the two screws securing the device to the drive cage.
For the Vostro 220s, lift the release latch that secures both the optical drive and the
1 | release latch | 2 | optical drive bay |
3media card reader
6.Slide the device out through the front of the computer.
7.If you are installing a replacement device, skip to step 5 in Replacing or Adding a Media Card Reader.
If you are removing the device permanently and the drive bay is to remain empty, proceed to step 8.
8.Disconnect the USB interface cable from the system board (see System Board Components), and remove the cable from the computer.
9.Install a
a.Holding the
b.Push the other end of the insert into the opening until it fits into place.
NOTE: To comply with FCC regulations, install the