Alienware P06T003, M11X R3 service manual Click Start → Control Panel→ System and Security→ System

2.Align the notch in the memory module with the tab in the memory- module connector.

3.Slide the memory module firmly into the connector at a 45-degree angle, and press the memory module down until it clicks into place. If you do not hear the click, remove the memory module and reinstall it.

NOTE: If the memory module is not installed properly, the computer may not boot.

1

3

memory-module connector	2	tab
notch

4.Replace the battery pack (see Replacing the Battery Pack).

5.Replace the base cover (see Replacing the Base Cover).

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.

6. Turn on the computer.

As the computer boots, it detects the additional memory and automatically updates the system configuration information.

To confirm the amount of memory installed in the computer:

Click Start → Control Panel→ System and Security→ System.

Back to Contents Page