1 | power cable | 2 | hard drive cable |
|
|
|
|
8.Check all connectors to be certain that they are properly cabled and firmly seated.
9.Replace the computer cover (Replacing the Computer Cover).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
10.Connect your computer and devices to electrical outlets, and then turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
Floppy Drive
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTE: If you are adding a floppy drive, see Installing a Floppy Drive.
Removing a Floppy Drive
1.Follow the procedures in Before You Begin.
2.Remove the computer cover (see Removing the Computer Cover).
3.Disconnect the power and floppy drive cables from the back of the floppy drive.
4.Unhook floppy drive cable from the clips on the processor shroud. Disconnect the other end of the floppy drive cable from the system board. Remove the floppy drive cable from the computer.
1 | power cable | 2 | floppy drive cable | 3 | floppy drive |
|
|
|
|
|
|
4 | sliding plate lever | 5 | sliding plate | 6 | processor shroud |
|
|
|
|
|
|