Dell 410 manual Dell Diagnostics Main Menu, Option Function, Tab Function

INTR2 Error	POST.	be replaced.
Invalid Boot	The operating system	Enter the system setup program (see
Diskette	cannot be located on drive	Entering System Setup)and confirm that
	A or drive C.	drive A or drive C is properly identified.
Keyboard Error	The BIOS has detected a	Ensure that nothing is resting on the
	stuck key.	keyboard; if a key appears to be stuck,
		carefully pry it up. If the problem persists,
		you may need to replace the keyboard.
KB/Interface	An error occurred with the	Ensure that nothing is resting on the
Error	keyboard connector.	keyboard; if a key appears to be stuck,
		carefully pry it up. If the problem persists,
		you may need to replace the keyboard.
No ROM Basic	The operating system	Enter the system setup program (see
	cannot be located on drive	Entering System Setup) and confirm that
	A or drive C.	drive A or drive C is properly identified.

Dell Diagnostics

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: The Dell Diagnostics works only on Dell™ computers.

1.Turn on (or restart) your computer.

2.When the DELL™ logo appears, press <F12> immediately.

If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft® Windows® desktop. Then shut down your computer (see "Turning Off Your Computer" on page 7) and try again.

3.When the boot device list appears, highlight Boot to Utility Partition and press <Enter>.

4.When the Dell Diagnostics Main Menu appears, select the test you want to run.

Dell Diagnostics Main Menu

1. After the Dell Diagnostics loads and the Main Menu screen appears, click the button for the option you want.

Option	Function
Express Test	Performs a quick test of devices. This test typically takes 10 to 20 minutes and requires no interaction on your part. Run Express Test first to
	increase the possibility of tracing the problem quickly.
Extended	Performs a thorough check of devices. This test typically takes an hour or more and requires you to answer questions periodically.
Test
Custom Test	Tests a specific device. You can customize the tests you want to run.
Symptom	Lists the most common symptoms encountered and allows you to select a test based on the symptom of the problem you are having.
Tree

2.If a problem is encountered during a test, a message appears with an error code and a description of the problem. Write down the error code and problem description and follow the instructions on the screen.

3.If you run a test from the Custom Test or Symptom Tree option, click the applicable tab described in the following table for more information.

Tab	Function
Results	Displays the results of the test and any error conditions encountered.
Errors	Displays error conditions encountered, error codes, and the problem description.
Help	Describes the test and may indicate requirements for running the test.
Configuration	Displays your hardware configuration for the selected device.
	The Dell Diagnostics obtains configuration information for all devices from system setup, memory, and various internal tests, and it displays
	the information in the device list in the left pane of the screen. The device list may not display the names of all the components installed on
	your computer or all devices attached to your computer.
Parameters	Allows you to customize the test by changing the test settings.

4. Close the test screen to return to the Main Menu screen. To exit the Dell Diagnostics and restart the computer, close the Main Menu screen.