Back to Contents Page
Removing and Installing Parts
Dell™ XPS™ 410 Service Manual
Removing the Computer Cover
Inside View of Your Computer
System Board Components
Memory
Cards
Drive Panels
Drives
Hard Drive
Floppy Drive
Media Card Reader
CD/DVD Drive
Battery
Power Supply
Processor
I/O Panel
Processor Fan
Card Fan
System Board
Replacing the Computer Cover
This chapter provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that the following conditions exist:
•You have performed the steps in Turning Off Your Computer and Before Working Inside Your Computer.
•You have read the safety information in your Dell™ Product Information Guide.
•A component can be replaced by performing the removal procedure in reverse order.
•You have the tools listed in Recommended Tools.
•You are familiar with Turning Off Your Computer.
When working inside the computer, be aware that the
Removing the Computer Cover
CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTICE: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the computer. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components.
1.Follow the procedures in Before You Begin.
2.If you have installed a security cable, remove it from the security cable slot.
NOTICE: Ensure that sufficient space exists to support the removed
NOTICE: Ensure that you are working on a level, protected surface to avoid scratching either the computer or the surface on which it is resting.
3.Lay your computer on its side with the computer cover facing up.
4.Pull back the cover release latch on the top panel.