Dell B110 service manual Removing a Floppy Drive

Page 38

See the documentation for your operating system for instructions.

15. Test the hard drive by running the Dell Diagnostics.

If the drive you just installed is the primary drive, install your operating system on the hard drive.

Floppy Drive

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.

1.Follow the procedures in Before You Begin.

2.Release and remove the front panel (see page 46).

NOTE: If you are adding a floppy drive, see Installing a Floppy Drive.

Removing a Floppy Drive

1.Disconnect the power and data cables from the back of the floppy drive and from the system board (see System Board Components).

2.Remove the floppy drive bracket from the computer:

a.Remove the bracket-securing screw for the floppy drive.

b.Remove the bracket for the floppy drive from the computer.

Image 38
Contents Abbreviations and Acronyms Recommended Tools Before You BeginGetting Started Turning Off Your ComputerOpen the computer cover Back to Contents Turn off your computerRemoving the Computer Cover Technical Overview Inside View of Your Computer System Board ComponentsPower Supply DC Connector Pin Assignments Minimum Current a Maximum Current a Pin Number Signal name Wire Color DC Power Connector P1DC Power Connector P2 DC Power Connector P6 DC Power Connectors P8 and P9DC Power Connector P4 Pin Number Signal Name 18-AWG Wire ColorDC Power Connector P7 Pin Number Signal Name 22-AWG Wire ColorComputer Information Technical SpecificationsMemory Audio ConnectorsVideo Expansion BusPhysical PowerControls and Lights EnvironmentalBack to Contents Remove and then reinstall the memory modules Advanced TroubleshootingPower Lights Network LightsSuggested Resolution Diagnostic LightsLight Pattern Problem Description Yellow LEDBeep Codes Code CauseSystem Messages System setup programEnter the system setup program, verify Message Possible Cause Corrective ActionFDD System Setup Screens System SetupEntering System Setup OverviewSystem System Setup OptionsDrive Configuration Hard-Disk Drive SequenceCPU Information Boot SequenceMemory Information Integrated DevicesChanging Boot Sequence for the Current Boot Boot SequenceOption Settings Power ManagementEnter system setup Clearing Forgotten PasswordsChanging Boot Sequence for Future Boots Replace the computer cover Hard Drive Power Supply Floppy Drive Battery Removing and Installing PartsMemory Installation Guidelines MemoryInstalling Memory Shut down the computer through the Start menuReplace the computer cover Cards PCI CardsBefore installing any cards Front Panel Removing the Front PanelRemoving the Front-Panel Insert Remove the computer coverReattaching the Front Panel Drives General Installation GuidelinesConnecting Drive Cables Hard DriveRemoving a Hard Drive Installing a Hard Drive Page Floppy Drive Removing a Floppy DriveInstalling a Floppy Drive CD/DVD Drive Removing a CD/DVD DriveInstalling a CD/DVD Drive Adding a Second CD or DVD Drive Page Processor Removing the ProcessorInstalling the Processor Page Fan Assembly Removing the Fan AssemblyReplacing the Fan Assembly Removing the System Board Remove the microprocessor heat sink Remove the fan assemblySystem Board Installing the System Board Reinstall the fan assemblyReplacing the Power Supply Power SupplyRemoving the Power Supply Battery Replace the computer cover Replacing the Computer Cover
Related manuals
Manual 116 pages 9.03 Kb Manual 116 pages 3.25 Kb Manual 54 pages 62.68 Kb