Dell B110 service manual Minimum Current a Maximum Current a

Page 7

The 250-W power supply can operate from an AC power source of 115 VAC or 230 VAC at 50 – 60 Hz. The power supply provides the DC operating voltages and currents listed in the following table.

Output Voltage1

Minimum Current (A)

Maximum Current (A)2

+12 VDC

0.0

16.03

+5 VDC

1.0/0.24

22.0

+3.3 VDC

0.1/0.05

18.0

-

-

-

–12 VDC

0.0

1.0

+5 VFP

0.0

2.0

1Outputs will meet and not exceed SELV requirements per electrical standards, i.e. UL 60950, IEC 60950, EN60950 PAR.2.3.

2Maximum continuous combined load on +5 VDC and +3.3 VDC outputs will not exceed 150 watts.

3Peak +12 VDC output power (up to 17.0 amps) will not exceed 15 seconds in duration. Under this condition, tolerance on the +12v output, is allowed to be +/- 10%.

4+5 VDC minimum load will be 0.2A when there is a minimum load of 0.3A on the +12 VDC and 0.42A on the +3.3 VDC outputs simultaneously. +5V min load is 1A for load transient tests.

5In system applications where +3.3VDC is not used, all other outputs will stay within regulation while the +3.3 VDC output

Image 7
Contents Abbreviations and Acronyms Turning Off Your Computer Before You BeginGetting Started Recommended ToolsTurn off your computer Open the computer cover Back to ContentsRemoving the Computer Cover Inside View of Your Computer System Board Components Technical OverviewPower Supply DC Connector Pin Assignments Minimum Current a Maximum Current a DC Power Connector P2 DC Power Connector P1Pin Number Signal name Wire Color Pin Number Signal Name 18-AWG Wire Color DC Power Connectors P8 and P9DC Power Connector P4 DC Power Connector P6Pin Number Signal Name 22-AWG Wire Color DC Power Connector P7Memory Technical SpecificationsComputer Information Expansion Bus ConnectorsVideo AudioEnvironmental PowerControls and Lights PhysicalBack to Contents Network Lights Advanced TroubleshootingPower Lights Remove and then reinstall the memory modulesYellow LED Diagnostic LightsLight Pattern Problem Description Suggested ResolutionCode Cause Beep CodesMessage Possible Cause Corrective Action System setup programEnter the system setup program, verify System MessagesFDD Overview System SetupEntering System Setup System Setup ScreensHard-Disk Drive Sequence System Setup OptionsDrive Configuration SystemIntegrated Devices Boot SequenceMemory Information CPU InformationPower Management Boot SequenceOption Settings Changing Boot Sequence for the Current BootChanging Boot Sequence for Future Boots Clearing Forgotten PasswordsEnter system setup Replace the computer cover Memory Removing and Installing PartsMemory Installation Guidelines Hard Drive Power Supply Floppy Drive BatteryShut down the computer through the Start menu Installing MemoryReplace the computer cover PCI Cards CardsBefore installing any cards Removing the Front Panel Front PanelRemove the computer cover Removing the Front-Panel InsertReattaching the Front Panel Hard Drive General Installation GuidelinesConnecting Drive Cables DrivesRemoving a Hard Drive Installing a Hard Drive Page Removing a Floppy Drive Floppy DriveInstalling a Floppy Drive Removing a CD/DVD Drive CD/DVD DriveInstalling a CD/DVD Drive Adding a Second CD or DVD Drive Page Removing the Processor ProcessorInstalling the Processor Page Removing the Fan Assembly Fan AssemblyReplacing the Fan Assembly System Board Remove the microprocessor heat sink Remove the fan assemblyRemoving the System Board Reinstall the fan assembly Installing the System BoardRemoving the Power Supply Power SupplyReplacing the Power Supply Battery Replace the computer cover Replacing the Computer Cover
Related manuals
Manual 116 pages 9.03 Kb Manual 116 pages 3.25 Kb Manual 54 pages 62.68 Kb