Dell 9300 manual Removing the Memory Module

Back to Contents Page

Memory Module

Dell™ Inspiron™ 9300 Service Manual

Removing the Memory Module

Replacing the Memory Module

Removing the Memory Module

CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

NOTE: Memory modules purchased from Dell are covered under your computer warranty.

NOTE: To get maximum performance/dual-channel memory bandwidth capability, both memory module connectors must contain memory modules and the modules must be of the same size and configuration.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Turn the computer over, loosen the two captive screws from the memory module cover, and remove the cover.

NOTICE: To prevent damage to the memory module connector, do not use tools to spread the securing clips that secure the memory module.

NOTICE: Handle memory modules by their edges, and do not touch the components on a module.

a.Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.

b.Remove the module from the connector at a 45-degree angle.