Dell 9300 manual Removing the Display Bezel

3 shoulder screws (4) 6 screw covers (2)

Removing the Display Bezel

CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

1.Follow the instructions in "Before Working Inside Your Computer."

2.Remove the display assembly.

3.Remove the six rubber screw-covers/display bumpers.

4.Remove the two screw covers and the four shoulder screws.

5.Remove the four M2.5 x 5-mm screws at the corners of the bezel.

NOTICE: Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel.

6.Use your fingers to separate the bezel from the display back cover by pulling the lower-right corner of the bezel down toward the bottom edge (A) of the display assembly to clear the tab on the bottom of the lower-right corner. Then pull the bezel toward the right side of the display assembly to clear the tab on the side (B) of the lower-right corner.

1display back cover

2tabs

7.Repeat step 6 for the lower-left corner of the bezel. Then use your fingers to release the snaps around the rest of the bezel and lift it away from the display panel.