Dell N3010 manual Replacing the Mini-Card

CAUTION: When the Mini-Card is not in the computer, store it in protective antistatic packaging. For more information, see "Protecting Against Electrostatic Discharge" in the safety information that shipped with your computer.

Replacing the Mini-Card

1.Follow the instructions in Before You Begin.

2.Remove the new Mini-Card from its packaging.

CAUTION: Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.

CAUTION: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and realign the card.

3.Insert the Mini-Card connector at a 45-degree angle into the connector on the system board.

4.Press the other end of the Mini-Card down into the slot on the system board and replace the screw that secures the Mini-Card to the system board.

5.Turn the system board over.

6.Follow the instructions from step 7 to step 21 in Replacing the System Board.

7.Connect the appropriate antenna cables to the Mini-Card you are installing. The following table provides the antenna cable color scheme for the Mini- Card supported by your computer.

Connectors on the Mini-Card Antenna Cable Color Scheme

WLAN (2 antenna cables)

Main WLAN (white triangle)

white

Auxiliary WLAN (black triangle) black

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.

8. Install the drivers and utilities for your computer, as required.

NOTE: If you are installing a communication card from a source other than Dell, you must install the appropriate drivers and utilities.

Back to Contents Page