Back to Contents Page
Camera Module
Dell™ Inspiron™ N3010 Service Manual
Removing the Camera Module
Replacing the Camera Module
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer.
Removing the Camera Module
1.Follow the instructions in Before You Begin.
2.Remove the battery (see Removing the Battery).
3.Remove the
4.Remove the memory module(s) (see Removing the Memory Module(s)).
5.Remove the keyboard (see Removing the Keyboard).
6.Remove the palm rest assembly (see Removing the Palm Rest Assembly).
7.Remove the display assembly (see Removing the Display Assembly).
8.Remove the display bezel (see Removing the Display Bezel).
9.Remove the display panel (see Removing the Display Panel).
10.Remove the two screws that secure the camera module to the display cover.
11.Remove the tape that secures the display cable to the connector on the camera module.
12.Disconnect the display cable from the connector on the camera module.
1 | screws (2) | 2 | camera module |
|
|
|
|
3 | display cable | 4 | tape |
|
|
|
|