1power button board cable 2 touch pad cable
3antenna cables (2)
10.Gently pull the antenna cables up from the bottom of the computer through the slot on the palm rest assembly.
11.Note the routing of the
12.Using a plastic scribe carefully pry out the palm rest assembly along the rear edge and then ease the palm rest assembly from the computer base.
1
3
palm rest assembly | 2 | antenna cables (2) |
|
|
|
plastic scribe |
|
|
|
|
|
CAUTION: Carefully separate the palm rest assembly from the computer base to avoid damage to the palm rest assembly.
13. Lift the palm rest assembly off the computer base.
Replacing the Palm Rest Assembly
1.Follow the instructions in Before You Begin.
2.Align the palm rest assembly on the computer base and gently snap the palm rest assembly into place.
3.Route the
4.Slide the antenna cables through the slot on the palm rest assembly to the computer base.
5.Replace the seven screws that secure the palm rest assembly to the computer base.
6.Slide the touch pad cable and power button board cable into their connectors on the system board, and press down on the connector latches to secure the cables.