Dell M1730 manual Removing the Processor, Installing the Processor

Back to Contents Page

Processor

Dell™ XPS™ M1730 Service Manual

Removing the Processor

Installing the Processor

Removing the Processor

CAUTION: Before working inside your computer, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer).

NOTICE: To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press to apply slight pressure to the center of the processor while turning the cam screw.

NOTICE: To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.

1.Follow the instructions in Before You Begin.

2.Remove the system board (see Removing the System Board).

3.Remove the processor thermal-cooling assembly (see Processor Thermal- Cooling Assembly).

NOTICE: When removing the processor, pull it straight up. Be careful not to bend the pins on the processor.

4.To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.

The ZIF-socket cam screw secures the processor to the system board. Take note of the arrow on the ZIF-socket cam screw.

1 processor 2 pin-1 corner of processor 3 ZIF socket

4ZIF-socket cam screw

5.Use a processor extraction tool to remove the processor.

Installing the Processor

NOTICE: Ensure that the cam lock is in the fully open position before seating the processor. Seating the processor properly in the ZIF socket does not require force.

NOTICE: A processor that is not properly seated can result in an intermittent connection or permanent damage to the processor and ZIF socket.