Dell M1730 manual Windows XP

1 memory module 2 securing clip

NOTICE: If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM1" before you install a module in the connector labeled "DIMM2." Insert memory modules at a 45-degree angle to avoid damaging the connector.

5. Ground yourself and install the new memory module:

NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.

a.Align the notch in the module edge connector with the tab in the connector slot.

b.Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

1 memory module 2 securing clip

6. Replace the memory module cover.

NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.

7.Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.

8.Turn on the computer.

As the computer boots, it detects the additional memory and automatically updates the system configuration information. If prompted, press <F1> to continue.

Confirm the amount of memory installed in the computer:

•Windows® XP

¡Right-click the My Computer icon on your desktop, then click Properties→ General.

•Windows Vista™

Click the Windows Vista Start button , right-click Computer, and then click Properties.

Back to Contents Page