Dell M1000E owner manual Module Port Mapping-Full-Height Blades, Standard LOM Dual-Port Mapping

Fabric A	Fabric B Mezzanine	Fabric C Mezzanine	I/O Bay A1,	I/O Bay B1,	I/O Bay C1,
	Card	Card	A2	B2	C2
			through	through
			module	module
Standard	Infiniband	Infiniband	Ethernet	Infiniband	Infiniband
Integrated	mezzanine card	mezzanine card	switch	switch	switch
LOM			module or	module	module
			pass-
			through
			module
Standard	Infiniband	Ethernet mezzanine	Ethernet	Infiniband	Ethernet
Integrated	mezzanine card	card	switch	switch	switch
LOM			module or	module	module or
			pass-		pass-through
			through		module
			module
Standard	Fibre channel	Ethernet mezzanine	Ethernet	Fibre	Ethernet
Integrated	mezzanine card	card	switch	channel	switch
LOM			module or	switch or	module or
			pass-	pass-	pass-through
			through	through	module
			module	module

I/O Module Port Mapping—Full-Height Blades

NOTE: The I/O port mappings in the following sections are applicable only to the I/O Pass-Through Modules.

Standard LOM (Dual-Port) Mapping

Each LOM has two port connections. For a full-height blade in bay n:

•Integrated LOM1, connection 1 connects to I/O module A1, port n.

•Integrated LOM1, connection 2 connects to I/O module A2, port n.

•Integrated LOM2, connection 1 connects to I/O module A1, port n+8.

•Integrated LOM2, connection 2 connects to I/O module A2, port n+8.

For example, in a full-height blade in slot 5:

•Integrated LOM1 connection 1 connects to I/O module A1, port 5.

•Integrated LOM1 connection 2 connects to I/O module A2, port 5.

•Integrated LOM2 connection 1 connects to I/O module A1, port 13.

•Integrated LOM2 connection 2 connects to I/O module A2, port 13.

NOTE: Even though PowerEdge M610x is a full-height blade system, only one network controller (LOM1) is available.

For PowerEdge M610x blade in bay n, the integrated NIC connects to I/O module A1, port n and I/O module A2, port n.

41