Dell 2009W appendix Setting Up the Monitor, Attaching the Stand, Connecting Your Monitor

Page 21

Back to Contents Page

Setting Up the Monitor

Dell™ 2009W Flat Panel Monitor User's Guide

Attaching the Stand

Connecting the Monitor

Organizing the Cables

Attaching the Dell Soundbar (optional)

Removing the Stand

Attaching the Stand

NOTE: The stand is detached and extended when the monitor is shipped from the factory.

Place the stand on a flat surface and follow these steps to attach the monitor stand:

1.Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.

2.Lower the monitor so that the monitor mounting area snaps on to or locks on to the stand.

Connecting Your Monitor

CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions.

To connect your monitor to the computer perform the following steps/instructions:

•Turn off your computer and disconnect the power cable.

•Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your computer. Do not use both cables on the same computer. Use both the cables only when they are connected to two different computers with appropriate video systems.

Connecting the White DVI Cable

Connecting the Blue VGA Cable

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Dell 2009W Flat Panel Monitor Users Guide About Your Monitor Solving ProblemsIdentifying Parts and Features Front View Product FeaturesAbout Your Monitor Front View Front panel controls Label DescriptionBack View USB connectors downstream Left view Right viewSide View Back view Back View with monitor stand LabelMonitor Specifications Power Management ModesBottom View Pin Assignments Pin Pin Side of the Connected Signal Cable NumberTmds RX1 Pin Number Pin Side Connector Transfer speed Data Rate Power ConsumptionPin Number Pin Side Signal Cable Universal Serial Bus USB InterfacePlug and Play Capability Flat Panel SpecificationsPage Appendix Operating the Monitor Using the Front PanelFront panel Button Input Source Select Description OSD Menu/SelectUsing the On-Screen Display OSD Menu Accessing the Menu SystemIcon Menu Description Submenus Select to exit the main menu Use this menu to activate Brightness/Contrast adjustmentBack Exit MenuVGA/DVI-D Display Setting submenu Display SettingsPage Page Page Page Page Setting Up the Monitor Connecting Your MonitorAttaching the Stand Attaching the Soundbar Organizing the CablesRemoving the Stand Troubleshooting Your Monitor Solving ProblemsCommon Problems Common Symptoms What You Possible Solutions ExperienceInformation, see Power Management Modes
Top Page Image Contents