1.Working from the rear of the monitor, attach Soundbar by aligning the two slots with the two tabs along the bottom rear of the monitor.
2.Slide the Soundbar to the left until it snaps into the place.
3.Connect the sound bar with the power brick.
4.Plug the power cables of the power brick into a nearby outlet.
5.Insert the lime green mini stereo plug from the rear of the Soundbar into the computer's audio output jack.
NOTE: The graphic is for illustration only. Product appearance may vary.
NOTE: The base removal is not necessary to install the sound bar. Shown with base detached for illustration purposes only.
Specification
System Frequency Response | 95 Hz to 20 kHz @ 10 dB below avg. SPL |
Total Power Output | 14 W continuous average power (all speakers operating) @ 10% (THD+N), 1 kHz (FTC |
| rated) |
Headphone Jack | 40 mW continuous average power (RL = 32Ω) @ 10% (THD+N), 1 kHz |
Output Power |
|
Input Sensitivity for | 500 ± 50 mVrms @ 1 kHz |
Rated Output |
|
Input Impedance | >10kΩ |
Maximum Input Signal | 2 Vrms |
Voltage |
|
Controls | Power On/Off Volume Control |
Input Cables | 3.0 m ± 0.1 m AWG26 black cable attached to enclosure, with 3.5 mm lime green stereo |
| plug |
Power Requirements | DC12V, 1.5A |
Power Cord Length | 305 mm +/- 15 mm AWG22 black cable attached to enclosure, with DC plug (5.5 x 2.1 x |
| 12 mm) |
Operating Temperature | 10°C to 40°C |
Range |
|
Humidity, | 95% RH @ 40°C |
Troubleshooting
The following table contains general information about common audio problems you might encounter.
COMMON | WHAT YOU EXPERIENCE | POSSIBLE SOLUTIONS |
SYMPTOMS |
|
|
No Sound | No power to Soundbar - the | Turn the Power/Volume knob on the Soundbar clockwise to the middle position; check if |
| power indicator is off. | the power indicator (green LED) on the front of the Soundbar is illuminated. |