Daewoo F109A1 manual Selecting a suitable location Connecting the monitor

Page 8

F109A1

BACK

3-2. Selecting a suitable location

3-3. Connecting the monitor

• 15 pin D-sub / DVI-D

19" Dual Function Monitor

NEXT

Place the monitor at least 30cm from other electrical or heat-emitting equipment and allow at least 10cm on each side for ventilation.

Place the monitor in a position where no light shines directly onto or is reflected on the screen.

To reduce eye strain, avoid installing the display unit against a bright background such as a window.

Position the monitor so that the top of the screen is no higher than eye level.

Position the monitor directly in front of you at a comfortable reading distance (around 45 to 90cm)

! Before you start cabling your monitor, check that the power is off on all units. To avoid any possibility of electric shock, always connect your equipment to properly earthed outlets.

1.Insert the other 15-pin/DVI-D signal cable connector into the 15-pin VGA/DVI-D connection on your computer and screw it down.

2.Plug the power cord connection to connection on the monitor.

3.Plug the other end of the power cord to your computer's main supply or to a 100V-240V earthed electrical outlet.

4.Turn on the monitor using the power switch and check that the power LED is on. If not, repeat steps 1,2,3 and 4 or refer to the Troubleshooting section of this guide.

5/22

Image 8
Contents User’s Guide Back Next F109A1 Introduction Safety Information F109A1 Cleaning and Maintenance Installing the monitor Selecting a suitable location Connecting the monitor Pin D-sub cable Analog RGB DVI-D cable Digital Tmds Audio system Setting the refresh rate Resolution Horizontal Frequency Refresh rate 10/22 11/22 1280x1024 H63.9 1280x1024 H63.9 14/22 15/22 16/22 17/22 Display power management Troubleshooting 20/22 21/22 Specifications