4-5. POWER MANAGEMENT
This section is used to configure the power management features. This <Power management Setup> option allows you to reduce power consumption. This feature turns off the video display and shuts down the hard disk after a period of inactivity.
MIBIOS SETUP - Power Management Setup
(C) 1998 American Megatrends, Inc. All Rights Reserved
Power Management /APM | Disab led |
Green PC Monitor Power State | Off |
Video Power Down Mode | Disabled |
Hard Disk Power Down Mode | Disabled |
Hard Disk Time Out (Minute) | Disabled |
Standby Time Out (Minute) | Disabled |
Suspend Time Out (Minute) | Disabled |
Throttle slow Clock Ratio | |
Modem Use IO Port | 3F8h/COM1 |
Modem Use IRQ | 3 |
Display Activity | Ignore |
Device 6 (Serial Port 1) | Monitor |
Device 7 (Serial Prot 2) | Monitor |
Device 8 (Parallel Port) | Ignore |
Device 5 (Floppy disk) | Monitor |
Device 0 (Primary master IDE) | Monitor |
Device 1 (Primary slave IDE) | Ignore |
Device 2 (Secondary master IDE) | Monitor |
Device 3 (Secondary slave IDE) | Ignore |
System Thermal | Ignore |
Thermal Slow Clock Ratio | |
CPU Critical Tempera ture | 65 /149 |
Power Button Function | On/Off |
Restore on AC/Power Loss | Last State |
Ring Resume From Soft Off | Disabled |
Lan Resume From Soft Off | Disabled |
Available Options :
Disabled
Enabled
ESC:Exit :Sel
PgUp/PgDn:Modify
F2/F3:Color
BIOS: Power Management Setup
Power Management /APM
Enabled this option is to enable the power management and APM (Advanced Power Management) features.
Green PC Monitor Power State
This option specifies the suspend mode of shutting down the cathode ray gun, if only the system is fixed a green function monitor, the power saving function is available.
Video Power Down Mode
This option specifies the power management state that the video subsystem enters after specified period of display inactivity has expired.
Hard Disk Power Down Mode
This option specifies the power management states that the hard disk drive enters after the specified period of display inactivity has expired.
Hard Disk time out(minute)
This item is used to set up the initial value of the waiting timer .the Hard Disk will turn into the suspend mode when the time is out if no operation applied to Hard Disk .
Standby Time Out (minute)
This item is used to set up the initial value of the waiting timer, the System will turn into the suspend mode when the time is out if no operation applied to system.
~耟Page 36 ~