Citizen Systems CBM-720, CBM-750, CBM-730 Installing and Changing the Paper, Installing the Paper

Page 21

CBM-710/720/730/750 User ’s Manual

6.4Installing and Changing the Paper

(1)Installing the Paper

1)Remove the paper cover.

2)Put the end of the paper off at a right angle as shown in figure 14.

Fig. 14

3)Put the end of the paper into the paper entrance of the printer. (Refer to figure 17.)

4)After turning the power switch on and confirming that the printer is in deselect (off line) status, press the LF switch to feed the paper into the printer.

5)In the case of the CBM-730, set the imprint face of the paper downward and put it into the paper entrance (If using 3.0" width paper, place the paper between 2 bars).

If necessary to adjust the sprocket-wheels' position, free them by the lever and slide to the appropriate position, and lock it back. (Refer to figure 15.)

15

CITIZEN

Image 21

Contents Page Declaration of Conformity Important Safety Instructions Sicherheitshinweis Contents 11.1 Features AccessoriesIntroduction CBM-710 23 R Type ClassificationsGeneral Specifications SpecificationsCBM-710 CBM-720 Print Format Paper SpecificationsBlock Diagram CBM-710 External Appearance External Appearance and Pars DescriptionsFront View CBM-720 External AppearanceCBM-730 External Appearance CBM-750 External Appearance Part Descriptions Operation Setting and Removing the Paper and Ribbon CoversOpening and Closing the Cutter Unit CBM-720. CBM-750 Installing the Cassette Ribbon Installing the Paper Installing and Changing the PaperCitizen Citizen Self Print Function Procedures for Actuating the Self Print FunctionPaper End Detector Changing the PaperInstallation of the CBM-750 Input Buffer BACK-UP Function Input Buffer Back-upClearing the Input Buffer Specifications Connector Pin AssignmentParallel Interface Input/Output Signals Description of Input/Output SignalsElectrical Characteristics Timing Chart Serial Interface DTR Description of Input/Output Signals Data Composition Error DetectionBuffering Data Receiving ControlOutput DTR, TD Ready Function Selection Setting DIP Switch DS1DIP Switch DS2 Serial interface specifications only DIP Switch and Slide Switch Locations Slide Switch Setting Serial interface specifications onlyControl Codes Print Control FunctionsInput Data Formats Enlarged character commandPaper feed command Enlarged character cancel commandPrint command Clear commandInitial Set Command Inverted character commandBuzzer Command Graphic Command Graphic Type Only Underline Command13 1/9 inch Line Feed Pitch Set Command Graphic Type 14 2/9 inch Line Feed Pitch Set Command Graphic TypePin Form Feed Command 2nd byte 4EH 3rd byte N7 N6 N5 N4 N3 N2 N1 Binary digital Skip Perforation Cancel CommandFull Cut Command 1st byte International Character Codes Character Code TablesIndividual Country Character Codes Maintenance Procedures MaintenanceExterior InteriorCBM-710 External DimensionsCBM-720 Paper Winder Unit AW-2 CBM-730 CBM-750 Information Systems Division Head Office