Citizen Systems CBM-910 manual Self-Printing Function

Page 21

4.5 Self-Printing Function

When activating self-printing function, be sure to start with a paper loaded (or in the printable state).

(1)Test printing

Turn the printer power on while pressing and holding the LF switch, and the printer starts printing the status of current setting of DIP switch (including the content of setting in case of serial printer) and all characters available with the printer.

The SEL lamp is held off and BUSY signal is output during test printing.

On completion of test printing, the printer enters the standby state awaiting print data.

(2)Hexadecimal dump mode

Turn the printer power on with the LF switch and SEL switch pressed and held. The printer prints Hexadecimal Dump characters and then prints all data sent from the host in hexadecimal code.

When data for the last line is not sufficient for full one line, data of the last line is printed out with SEL switch pressed and deselected (OFF LINE).

This mode lasts till power is turned off.

Example of Printing in Dump Mode

31	32	33	34	35	36	37	38	12345678
39	3A	3B	3C	3D	3E	3F	40	9*+,-./@
41	42	43	44	45	46	47	48	ABCDEFGH
49	4A	4B	4C	4D	4E	4F	50	IJKLMNOP
51	52	53	54	55	56	57	58	QRSTUVWX

— 18 —

Image 21

Contents CBM-910 Type CE Marking Declaration of Conformity Compliance Statements General Precautions Safety Precautions -WHICH should be Strictly Observed Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Features AccessoriesIntroduction Type Classifications TypeAC Adapter CBM-910II-24 CBM-910II-40 SpecificationsExternal Appearance External Appearance and Part DescriptionsOFF Part DescriptionsConnection of the AC Adapter OperationsSetting of the Printer Cover Setting Ribbon Cassettes Setting Paper Special Remarks Concerning Paper Self-Printing Function Japan 910JPN Memory Switch SettingUSA = U.S.A Paper-Near-End, Mechanical Alarm, Memory Error General Remarks Connector Pin Assignment Pin Signal NameParallel Interface Description of Input/Output Signals Electrical Characteristics Serial Interface Host-Printer Pin Signal Name Signal Direction Function RS-232CDTR Data Terminal Ready Description of Input/Output SignalTTL circuit Input Reset Receiving Control and Buffering Error DetectionSwitch No Function DIP Switch SettingFactory Setting Switch No Parity Baud Rate Factory SettingParallel Interface Type Symbol Code Function CBM910 IDP3110 Hexadecimal Print Control FunctionList of Control Codes Control Code Details Abcd Page Character Code Table CountryESC Page FF FF FF FF FF FF For 40-column model 3110 emulation Page Model 123 CR Function Content of Setting Ascii + 910 Emulation International 910 Emulation Japan Character Code TableCodepage PC437 USA, Standard Europe Katakana Codepage PC858 Multilingual Codepage PC860 Portuguese Codepage PC863 Canadian-French Codepage PC865 Nordic Codepage PC852 Eastern Europe Codepage PC866 Russian Codepage PC857 Turkish Codepage WPC1252 Windows Latin1 Codepage PC864 Arabic Codepage PC869 Greek International Character Code Table External Dimensions Page