Citizen Systems CBM-910 manual DIP Switch Setting, Serial Interface Type, Switch No Function

7.DIP SWITCH SETTING

7.1Serial Interface Type

Switch No.		Function	OFF	ON	Factory Setting
	1	Character direction	Normal	Inverted	OFF
*1	2 (3110)	CR	—	—	OFF
*1	2 (910)	CR	Ignore CR	CR + LF	OFF
	3	Reset in	Disable	Enable	ON
	*2 4	Bit length	8 bits	*3 7 bits	OFF

*1: A difference is developed by the emulation set by the memory switch.

*2: After setting DIP switch No. 4 to ON, turning the printer power on with the SEL switch pressed and held causes the printer to enter the Manual memory switch setting mode. With normal power on operation, bit length setting is active.

*3: This setting may cause some restrictions such as limiting the argument of control code or incomplete format of data in bit image printing.

Baud rate and parity selection

	Switch No.			Parity	Baud Rate	Factory Setting
8	7	6	5
OFF	OFF	OFF	OFF	None	4800	O
OFF	OFF	OFF	ON	None	1200	—
OFF	OFF	ON	OFF	None	2400	—
OFF	OFF	ON	ON	None	4800	—
OFF	ON	OFF	OFF	None	9600	—
OFF	ON	OFF	ON	None	19200	—
OFF	ON	ON	OFF	Odd	1200	—
OFF	ON	ON	ON	Odd	2400	—
ON	OFF	OFF	OFF	Odd	4800	—
ON	OFF	OFF	ON	Odd	9600	—
ON	OFF	ON	OFF	Odd	19200	—
ON	OFF	ON	ON	Even	1200	—
ON	ON	OFF	OFF	Even	2400	—
ON	ON	OFF	ON	Even	4800	—
ON	ON	ON	OFF	Even	9600	—
ON	ON	ON	ON	Even	19200	—

— 31 —