Citizen Systems CBM-910 manual Control Code Details

Page 37

8.2 Control Code Details

(1) Command for Line Feed After Printing (CR/LF)

By entering CR (0DH)/LF (0AH) codes, data in the print buffer is printed followed by a line feed. Without data in the print buffer, only a line feed is performed. This command is ignored just after buffer full in case of 910 emulation.

CR and LF are valid in the following conditions.

910 Emulation

	DS2-ON	DS2-OFF
Serial	CR and LF	LF only
Parallel	CR and LF	LF only

3110 Emulation

	DS2-ON	DS2-OFF
Serial	CR only	CR only
Parallel	LF only	CR only

(2) SI/SO and US/RS Commands

SI/SO codes function in the same manner as US/RS as long as 8-bit data are assigned (serial communication data bit length), which, however, are divided, under 7-bit assignment, into SI (20H~7FH characters) print assignment and SO (A0H~FFH characters) print assignment functions.

1.Standard letter assignment (SI/US) command:

With SI (0FH)/US (1FH) codes input, lateral enlargement is cancelled and

the data following are printed in standard letters. This command can cancel only lateral enlargement, which dose not apply to ⋅4 enlargement.

— 34 —

Image 37

Contents CBM-910 Type CE Marking Declaration of Conformity Compliance Statements General Precautions Safety Precautions -WHICH should be Strictly Observed Page Precautions for Installation Precautions for Handling Table of Contents External Dimensions Accessories FeaturesIntroduction Type Type ClassificationsAC Adapter CBM-910II-24 CBM-910II-40 SpecificationsExternal Appearance External Appearance and Part DescriptionsOFF Part DescriptionsConnection of the AC Adapter OperationsSetting of the Printer Cover Setting Ribbon Cassettes Setting Paper Special Remarks Concerning Paper Self-Printing Function Japan 910JPN Memory Switch SettingUSA = U.S.A Paper-Near-End, Mechanical Alarm, Memory Error General Remarks Pin Signal Name Connector Pin AssignmentParallel Interface Description of Input/Output Signals Electrical Characteristics Serial Interface Host-Printer Pin Signal Name Signal Direction Function RS-232CDTR Data Terminal Ready Description of Input/Output SignalTTL circuit Input Reset Receiving Control and Buffering Error DetectionSwitch No Function DIP Switch SettingFactory Setting Switch No Parity Baud Rate Factory SettingParallel Interface Type Print Control Function Symbol Code Function CBM910 IDP3110 HexadecimalList of Control Codes Control Code Details Abcd Page Character Code Table CountryESC Page FF FF FF FF FF FF For 40-column model 3110 emulation Page Model 123 CR Function Content of Setting Ascii + 910 Emulation International 910 Emulation Japan Character Code TableCodepage PC437 USA, Standard Europe Katakana Codepage PC858 Multilingual Codepage PC860 Portuguese Codepage PC863 Canadian-French Codepage PC865 Nordic Codepage PC852 Eastern Europe Codepage PC866 Russian Codepage PC857 Turkish Codepage WPC1252 Windows Latin1 Codepage PC864 Arabic Codepage PC869 Greek International Character Code Table External Dimensions Page