Antex electronic SX-6, SX-34, SX-5e, SX-36 Volume, Installing and Using Multiple Cards in a System

Page 32

Volume:

These controls allow changing the volume of the playback only.

INSTALLING AND USING MULTIPLE CARDS IN A SYSTEM

When using more than one card in a system, each card must have a different adapter number. This is set by using the jumpers on top of the card. The Antex Driver must be set up to have a different Address and Interrupt for each card. In Win NT, go to “Start”, “Settings”, “Control Panel”, “Multimedia”, “Devices”, “Audio Devices”, “Audio for Antex Digital Audio Driver”, “Settings”. For each adapter number, make sure the correct model card is se- lected and that there is a different Address and Interrupt for each card. Each device on each card is accessible in the Antex Demo by using the pull down menu. Open as many instances of the Antex Demo as needed to access the desired number of de- vices/cards.

DUAL DEVICE OPERATION

Dual device mode can be accessed by opening 2 instances of the Antex Demo application. Note that in this mode, both devices (files) must have the same sample rate. File formats do not have to be the same. For example, you can play back a PCM16 file and an MPEG file at the same time, provided they are both re- corded at the same sample rate. The limiting factor in dual device mode is the processing power of the DSP. The tables below show the capabilities of each card.

27

Image 32
Contents September 17 Rev. E Antex Electronics CorporationTh Street GARDENA, CaliforniaDeclaration of Conformity Table of Contents SX-34 Mixer and Block Diagram SX-6 Mixer and Block Diagram Figures Card Installation IntroductionJumper Settings & Connections SX-5e,6,34,35 & SX-36 Jumper SettingsAddresses and Interrupts Making Connections to the CardPage SX-35/36 Connector Description SX-35/36 ConnectionsLine I/0 JP8 AUX in JP9 MIC JP7SX-34 Connector Description Output Header JP5AUX Header JP6 Microphone Header JP7Mono Header JP4 SX-6 Connector Description SX-6 ConnectionsLine OUT JP2 Microphone Input JP3SX-5e Connector Description Balanced and Unbalanced SignalsImpedance and Signal Levels Playback and Record Devices COMPRESSION, Data RATES, and Networks ISO/MPEG-1 Bitrates 32 KHz 44.1 KHz 48 KHz Driver Installation Windows Setup Tips Upgrade Driver, WINSetup Tips Upgrade Driver, WIN Windows NT Antex Application Software Installation Using Windows Demonstration Software Sample RateCompression Mpeg BitratesWave Device ChannelsVU Meters File Record/StopDual Device Operation VolumeInstalling and Using Multiple Cards in a System Mixer and Block Diagrams SX-36 Mixer and Block Diagram Page Page SX-36 Mixer SX-36 Block Diagram SX-34 Mixer and Block Diagram SX-34 MixerSX-34 Block Diagram SX-6 Mixer and Block Diagram SX-6 Mixer SX-6 Block Diagram SX-5e Mixer and Block Diagram SX-5e MixerPage SX-5e Block Diagram Antex Meter Antex MeterAntex Meter pull-down menu Antex Meter options Page Troubleshooting Files I record sound dull Files recorded are of poor quality There are dropouts or pops and clicksTECHNICAL/ORDERING Information Toll Free 800 Phone 310 FAX 310Terms Connectors for Male HeadersAppendix Page SX-36 SpecificationsAll Cards as applicable SX-34 SX-6SX-5e About Digital AudioPage Analog-to-Digital Digital-to-Analog