Antex electronic SX-36, SX-6, SX-34, SX-5e user manual Troubleshooting

Page 51

TROUBLESHOOTING

I get an error message when trying to run the Antex Demo program.

1.Card did not install correctly because of an I/O or interrupt conflict. In Win NT, go to “Start”, “Settings”, “Control Panel”, “Multimedia”, “Devices”, “Audio Devices”, “Audio for Antex Digital Audio Driver”, “Settings”. In this dialog box, make sure the correct model Antex Audio Card is selected, and try changing the Interrupt number and/or Address.

In Win 95/98, go to “Control Panel”, “System”, “Device Man- ager”. Click the “+” sign next to “Sound, video, and game controllers”. Select the Antex card, then click on “Properties”. Select the “Resources” tab, and try changing the Interrupt Re- quest or Input/Output Range. Make sure you select a valid setting for the Antex card and that the dialog box shows that there are no conflicting devices in your system at the selected Interrupt or I/O range.

If you suspect another card in your system may be conflicting with the Antex Card, power down your computer and remove any cards you think may be conflicting and try again. Also, in the CMOS settings for your motherboard, make sure the Inter- rupt you are trying to use is “Reserved for ISA”.

2.Make sure the Antex Driver is running. In Win NT, go to “Start”, “Settings”, “Control Panel”, “Devices”. Check the An- tex Digital Audio Driver and make sure it is Started and on Automatic.

3.Try removing and re-installing the driver. Removing the driver is particularly difficult in Windows 95. Check the Antex web- site or with tech support for an “uninstall” program.

46

Image 51
Contents GARDENA, California September 17 Rev. EAntex Electronics Corporation Th StreetDeclaration of Conformity Table of Contents SX-34 Mixer and Block Diagram SX-6 Mixer and Block Diagram Figures Introduction Card InstallationSX-5e,6,34,35 & SX-36 Jumper Settings Jumper Settings & ConnectionsMaking Connections to the Card Addresses and InterruptsPage SX-35/36 Connections SX-35/36 Connector DescriptionLine I/0 JP8 MIC JP7 AUX in JP9Output Header JP5 SX-34 Connector DescriptionMicrophone Header JP7 AUX Header JP6Mono Header JP4 SX-6 Connections SX-6 Connector DescriptionMicrophone Input JP3 Line OUT JP2Balanced and Unbalanced Signals SX-5e Connector DescriptionImpedance and Signal Levels Playback and Record Devices COMPRESSION, Data RATES, and Networks ISO/MPEG-1 Bitrates 32 KHz 44.1 KHz 48 KHz Setup Tips Upgrade Driver, WIN Driver Installation WindowsSetup Tips Upgrade Driver, WIN Windows NT Antex Application Software Installation Sample Rate Using Windows Demonstration SoftwareMpeg Bitrates CompressionChannels VU MetersWave Device Record/Stop FileVolume Installing and Using Multiple Cards in a SystemDual Device Operation Mixer and Block Diagrams SX-36 Mixer and Block Diagram Page Page SX-36 Mixer SX-36 Block Diagram SX-34 Mixer SX-34 Mixer and Block DiagramSX-34 Block Diagram SX-6 Mixer and Block Diagram SX-6 Mixer SX-6 Block Diagram SX-5e Mixer SX-5e Mixer and Block DiagramPage SX-5e Block Diagram Antex Meter Antex MeterAntex Meter pull-down menu Antex Meter options Page Troubleshooting Files I record sound dull There are dropouts or pops and clicks Files recorded are of poor qualityToll Free 800 Phone 310 FAX 310 TECHNICAL/ORDERING InformationConnectors for Male Headers AppendixTerms Page Specifications All Cards as applicableSX-36 SX-6 SX-34About Digital Audio SX-5ePage Analog-to-Digital Digital-to-Analog