Set the board number with jumpers as shown below. If only one board is being used, leave the jumpers off (sets to board number one). When using more than one card in a computer, each board must be given a different number by setting the jumpers differ- ently on each card. Any model Antex Card may be used with any other model Antex Card. All model Antex Cards use the same jumper arrangement to set the board number.
JUMPER SETTINGS & CONNECTIONS
J1 |
SX-5e/6/34 35/36
Top View
24
13
24
13
24
13
24
13
Board 1 | Board 2 | Board 3 | Board 4 | |
| Covered by jumper |
|
| |
|
|
| ||
|
|
|
|
|
Figure 1. SX-5e,6,34,35 & SX-36 Jumper Settings
The jumpers are oriented vertically so that they may be easily changed without having to remove the card from the computer slot if they should need to be changed later. These jumpers only set the board number, allowing for more than one board in a com- puter. They do not set interrupts.
2