Allied Telesis 86253-07 PCR 31106 Module MLD Level, PCR 31119 Module LOG Level, PCR Module IPG

Page 10

10

Patch Release Note

PCR: 31106 Module: MLD

Level: 2

When the device received a version 1 Query packet, it become a non-querier on that interface, even if it should have remained as the querier. This issue has been resolved.

PCR: 31118

Module: SWI

Level: 2

When the TYPE parameter was specified for the ADD SWITCH L3FILTER command, the type was sometimes a different value in the device’s hardware table. This issue has been resolved.

PCR: 31119 Module: LOG

Level: 2

The maximum value that the MESSAGES parameter accepted for the CREATE LOG OUTPUT command was different from the value that could be set with the SET LOG OUTPUT command. The DESTROY LOG OUTPUT command did not release the NVS memory that was reserved for the output. These issues have been resolved.

PCR: 31122 Module: RMON

Level: 3

The etherHistoryIntervalStart node in the etherHistoryTable showed incorrect values for the first and last 30 second interval periods. This issue has been resolved.

PCR: 31127

Module: FIREWALL

Level: 2

If a rule based NAT was added to the firewall’s public interface, the firewall forwarded ICMP Request packets even if ICMP forwarding was disabled. This issue has been resolved.

PCR: 31128

Module: IPG

Level: 2

When a large number of directed broadcast packets were received, CPU usage increased up to 100%. This occurred because a log message was generated each time a directed broadcast packet was deleted. This issue has been resolved. Log messages are now rate-limited to a maximum of one log message every 10 seconds for a directed broadcast flow. After the first deletion is logged, subsequent log messages include a counter showing the number of directed broadcast packets in the same flow that were deleted since the last log message.

PCR: 31129

Module: IPX2

Level: 2

A fatal error occurred if IPX was disabled and then re-enabled when there was a high rate of incoming IPX traffic on the device. This issue has been resolved.

PCR: 31132 Module: DHCP

Level: 2

The DHCP server did not take any action when it received a DHCP decline packet. This was because the device only checked the ciaddr field in the packet, and not the RequestedIPAddress option. This issue has been resolved.

PCR: 31133

Module: IPG

This PCR introduces an enhancement that extends an issue that was resolved in PCR 03890, in which switch port entries are only created for special router multicast addresses. It is now possible to specify reserved multicast addresses that will be treated as multicast packets from routers. Use the following commands to configure this feature.

Patch 86253-07 for Software Release 2.5.3 C613-10382-00 REV E

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Patch For Rapier Series Switches PCR Module IPG Level PCR Module Firewall LevelPCR Module PIM, PIM6 Level PCR Module IPv6 LevelPCR 31202 Module QOS Level PCR Module PIM6 LevelPCR Module SWI Level PCR Module Vrrp LevelPCR Module SWI, SW56 Level PCR Module L3F LevelPCR Module VLAN, IPG Level PCR 31258 Module IPG, DhcpPCR Module NTP Level PCR Module CURE, IPG, ATK LevelPCR 40006 Module LOG Level PCR Module IPG, Ospf LevelPCR Module PIM Level PCR Module STP LevelPCR Module TTY Level PCR Module PKI LevelPCR Module Utility Level PCR Module Http LevelPCR Module SWI Level PCR Module FFS Level PCR Module Ldap LevelPCR Module File Level PCR 31098 Module Dhcp LevelPCR 31122 Module Rmon Level PCR 31106 Module MLD LevelPCR 31119 Module LOG Level PCR Module IPX2 LevelADD Igmpsnooping Routeraddress Show Igmpsnooping Routeraddress PCR Module Rstp LevelPCR 31147 Module Dhcp Level PCR 31152 Module Dhcp LevelPCR 31159 Module FW, Vlan Level PCR Module User LevelPCR 02414 Module IPV6, SWI, IPG, Vlan PCR Module BGP, IP LevelPCR 02577 Module IPG, LOG Level PCR Module ETH, IPG, IPv6, IPX Level PCR Module OSPF, IPG LevelPCR 03622 Module Enco Level PCR Module TTY, User Level PCR Module BGP LevelPCR 03751 Module Mlds Level PCR Module Ikmp Level PCR Module Install LevelPCR Module ETH Level PCR 03801 Module Mlds LevelPCR Module IPG, IPV6 Level PCR Module Ping Level PCR 03870 Module SWI, Vlan LevelPCR 03874 Module Dhcp Level PCR Module DHCP, Telnet LevelPCR 03895 Module Dhcp Level PCR Module Switch LevelPCR Module IGMP, SWI Level PCR 03914 Module IPG, Vlan LevelPCR Module Ipsec Level PCR Module BGP, IPG Level PCR 31001 Module Dhcp LevelPCR 031020 Module PIM Level PCR 03691 Module Dvmrp Level PCR Module IPG, SWI LevelPCR 03515 Module Dhcp Level PCR 03698 Module Dvmrp LevelPCR 03708 Module Dhcp Level PCR Module IP LevelPCR Module Rsvp Level PCR 03779 Module Dhcp LevelPCR 03788 Module Dhcp Level PCR 03799 Module Dhcp LevelEnable and Disable Icmp Messages Enable IP Icmpreply MLD Snooping Igmp Snooping All-Group Entry Show IP Igmp Enable IP Igmp Allgroup Availability

86253-07 specifications

The Allied Telesis 86253-07 is a high-performance, versatile switch designed for enterprise networking environments. With its robust feature set and advanced technologies, the 86253-07 caters to a wide range of networking applications, making it an optimal choice for businesses seeking reliable and scalable connectivity solutions.

At the core of the Allied Telesis 86253-07 is its capability to deliver high-speed data transfer, accommodating demanding applications such as VoIP, video conferencing, and large file transfers. The switch supports Gigabit Ethernet ports, providing speeds of up to 1 Gbps for seamless connectivity between devices. This performance is supplemented by its Layer 2 and Layer 3 switching capabilities, allowing for efficient data routing and management across complex networks.

One of the notable features of the 86253-07 is its support for Power over Ethernet (PoE). This technology simplifies the deployment of network devices like IP cameras and wireless access points, as it enables the switch to deliver power and data over a single Ethernet cable. This not only reduces installation costs but also enhances flexibility in network design.

The switch also offers advanced security features to protect sensitive data and network infrastructure. It incorporates various protocols such as IEEE 802.1X for port-based network access control, ensuring that only authorized devices can connect to the network. Additionally, features like VLANs (Virtual Local Area Networks) allow for effective segmentation of network traffic, further enhancing security and performance.

Allied Telesis ensures that the 86253-07 is easy to manage and monitor with its user-friendly interface. The switch supports management protocols like SNMP (Simple Network Management Protocol) and provides web-based management options, making it accessible for IT administrators to configure and troubleshoot the network efficiently.

Another significant characteristic is its reliability and durability. Built with high-quality components, the 86253-07 is designed to withstand varying environmental conditions, ensuring uninterrupted network operation in challenging settings.

In summary, the Allied Telesis 86253-07 is a powerful switch equipped with Gigabit Ethernet, PoE support, advanced security features, and straightforward management options. Its combination of performance, reliability, and flexibility makes it an excellent solution for enterprises looking to enhance their networking capabilities.
Top Page Image Contents