User
Main Menu and Settings
1.Press MENU button on Remote Control Handset to enter MAIN MANU as listed below,
BRIGHTNESS CONTRAST SATURATION SHARPNESS COLOR LANGUAGE RECALL EXIT
2.Please use ▼ or ▲ button to select the item you want to adjust, then press MENU button again to get into each setting value. Press ► button to increase each value or press ◄ button to decrease each value.
In the MAIN MANU you can select RECALL and then press MENU button to set
After all setting done, you can either select EXIT and press MENU button to go out the MAIN MANU or it will go out from MAIN MANU automatically around 20 seconds later.
3.Select Wireless Channel
a. When the WiFi signal quality is poor the
“WIRELESS OVERLOAD”
b. As it is very often caused by other users using the same or adjacent channel, we can change the 802.11a wireless channel to get best receiving quality. There are total 11 channels you can select from : channel 036, 040, 044, 048, 052, 056, 060, 064, 149, 153 and 157. The initial default channel is set on channel 36.
c. Procedure to select wireless channel is as following,
i)Press WIRELESS button on the remote to see current setting. The default is 036.
ii)Press WIRELESS button again until you have the channel you want and press ENTER button. The on screen display will confirm changed to the wireless channel number you selected.
4.BITRATE Adjustment
a.The BITRATE setting sets the transmitting data compression ratio. If “LOW” is selected, it indicates that the data compression ratio is high. It effectively reduce the data transmitting load which might improve the wireless overload status, bit it will lower signal quality. The default is “MID”.
b.Press the BITRATE button on the remote to enter the Quality Low or Mid or High adjustment screen. Press ENTER to set the Quality (BIT RATE) level you selected.
Page 8 of 12