|
| Troubleshooting | ||
|
|
|
| |
Message | Procedure | Reference Page | ||
Send error. | An error has occurred during |
|
| |
#### | error codes and their descriptions are as follows. |
|
| |
1101: The server name of the SMTP server is not set correctly. | — | |||
| ||||
| Use COMMAND CENTER and register the SMTP server name |
|
| |
| correctly. Refer to Chapter 6 in Advanced Operation Guide, |
|
| |
| Advanced Page. |
|
| |
| 1105: The SMTP protocol setting is turned off. Use COMMAND | — | ||
| CENTER and turn on the SMTP protocol setting. Refer to |
|
| |
| Chapter 6 in Advanced Operation Guide, Advanced Page. |
|
| |
| 1106: The Sender Address setting under | — | ||
| registered. Use COMMAND CENTER and register the Sender |
|
| |
| Address. Refer to Chapter 6 in Advanced Operation Guide, |
|
| |
| Advanced Page. |
|
| |
| 210#: The network cable is disconnected or the hub that it is |
|
| |
| connected to is not operating properly. Check to see whether the |
| ||
| cable is not connected properly or the hub is not working properly. |
|
| |
| The server name of the SMTP server is not set correctly. Use |
|
| |
| COMMAND CENTER and register the SMTP Server Name |
|
| |
| correctly. Refer to Chapter 6 in Advanced Operation Guide, | — | ||
| Advanced Page. | |||
|
|
| ||
| 220#: The network cable has become disconnected during |
| ||
| transmission or the hub that it is connected to has stopped |
|
| |
| operating. Check to see whether the cable is not connected |
|
| |
| properly or the hub is not working properly. |
|
| |
| 3101: SMTP Authentication error. Consult with your network |
|
| |
| administrator to verify that the Login Account Name and Login | — | ||
| Password required for SMTP Authentication are correct. Refer to |
|
| |
| Chapter 6 in Advanced Operation Guide, Advanced Page. |
|
| |
| The SMTP server is not operating properly. Check with your |
|
| |
| network administrator to find out whether or not the SMTP server | — | ||
| is working properly. | |||
|
|
| ||
|
|
|
| |
Toner low. | Toner is running low. Replace the toner container using a new |
| ||
| toner kit as soon as possible. |
|
| |
|
|
|
| |
Waste toner near full. | Remove the process unit from the machine. Gently shake the | — | ||
| process unit horizontally a few times. Reinstall it into the machine. |
|
| |
| The machine will stop printing soon, contact your service |
|
| |
| representative or authorized service center. |
|
| |
|
|
|
| |
Waiting to scan. | The memory to execute the job is insufficient. The job will be | — | ||
| automatically resumed, after the memory capacity to execute is |
|
| |
| secured. If you want to cancel the job, press the left select key. |
|
| |
|
|
|
|