Recover IP Settings

System Conﬁguration

If you have lost your IP settings and can no longer access screens, you can force a network reset to conﬁgure the AWI to the default Local Network Conﬁguration.

NOTICE

To avoid damage to the circuit board, wear Part No. 112190 grounding strap, and ground appropriately.

1.Turn off power to the AWI unit.

2.On the AWI computer board (TS-7800), remove the jumper from JP1. Put it on DIO pin pair 1 (noted by dot).

JP-1

DIO-1

NOTICE

Be certain you move the jumper only to DIO pin pair 1. Other placement of the jumper will damage the board.

3.Power up the AWI and wait one minute, then power it down again.

4.Remove the jumper from DIO 1. Put it back on JP1.

5.Power up the unit. The system will operate in default Local Network Conﬁguration. To login, type http://gracoawi or http://192.168.178.200 in the browser address bar. Press Enter.

6.The Login screen appears. Log in with the login and password you set up. Your settings will be intact.

ti21708a

332459A