Hypercom manual Installation Procedures, Power-Up the ICE 5700 Terminal

Installation Procedures

This section contains important information that will help properly install ICE 5700 terminal.

Power-Up the ICE 5700 Terminal

Use the following procedures to power up the ICE 5700 terminal.

Step-by-Step

To power up the ICE terminal:

1.Connect the +24 Vdc power cable from the AC Adaptor to the three-pin terminal socket labeled POWER on the back panel of the ICE 5700 terminal.

2.Plug the AC Adaptor into a 110-Volt grounded power receptacle. Be sure the connector is firmly seated. When the power is connected successfully, the terminal beeps twice and then performs a self-test and diagnostic routine.

Power socket

Figure 2-1. ICE 5700 power socket