RadioLAN manual Initial IP Address Setup, Connect the DockLINK

Initial IP Address Setup

Before you can manage the DockLINK, from the local station, for example, a PC, the DockLINK must contain a valid network IP Address. There are two ways to assign an IP Address to the DockLINK:

∙Using the connection between the DockLINK and a station’s Network Interface Card.

∙A VT-100 terminal connection to the DockLINK Local Port

This section describes in detail each method for assigning the DockLINK an IP Address.

Connect the DockLINK

	Network
PC	Interface
	Card

DockLINK

Category 5 Cable

Figure 9: Quick Configuration

To use the IP ASSIGN Utility, you must first connect DockLINK to the station’s 10BaseT Network Interface Card. The station must not be running a DHCP server while performing this procedure.

1.Determine the method that you are using to assign the IP Address:

890-010 12/04/98 Page 13 © 1998 RadioLAN.