ELECTRICAL CONNECTION OF THE SYSTEM
WARNING
Personal Serious Injury Hazard
Power supply can cause severe electrical shock.
Disconnect power supply before installation. All wiring should be in accordance with NEC.
1.Bring power to the Power Junction Module and use appropriate
2.Install power conduit connector.
3.Using supplied WAGO connector terminals, connect assembly wires to power supply. (Line in to black, neutral to white, and earth ground to green).
4.Attach the Power Junction Module cover with two nuts.
WARNING
UV Light Hazard
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
Never look at the lamps while illuminated. Only view illumination by way of view port accessory. To prevent exposure to ultraviolet light, disconnect power to the
WARNING
The electrical supply circuit connected to this UV appliance must be routed through an electrical interlock switch placed on the HVAC system duct access panels and doors to prevent accidental UV exposure when servicing the air ducts or equipment.
LAMP INSTALLATION
CAUTION
Breakable Glass Hazard
Can cause personal injury.
Be careful when inserting lamp into lamp base. Wear protective gloves when handling lamp.
1.To install lamps into Lamp Modules. Slide lamp and black clip into the lamp module as shown in the below picture:
19-2021 Rev E, 06/05/07
10