5.Remove the sensor cleaning swab, store it in a safe place and protect it from dust.
Calibrate the PhotoLink Scanner
If the scanned image looks fuzzy or there are strange stripes on it, the scanner may need calibrating in order for the sensor to resume its original precision. To calibrate the scanner:
1.Follow the instructions on page 24 to clean the roller and image sensor, and then follow the instruction in “Initial Setup” on page 10 to prepare the scanner for scanning.
2.Insert the calibration card as shown. The scanner will scan the pattern on the calibration card and perform calibration to the sensor inside automatically.
Note: Make sure that the calibration card is inserted in the correct direction, otherwise the calibration won’t work.
Storing the PhotoLink Scanner
If the scanner will not be used for a prolonged period of time, follow the instructions below to store the scanner for future use.
1. Disconnect the scanner from power supply.
27