Users Manual & Installation Guide
PV- 1800: Power supply module with GSM MODEM
| ST1 |
| Base address | |
1 | 2 |
| 3 | COM_A |
0 | 0 |
| 0 | Disabled |
0 | 0 |
| 1 | 2C8 |
0 | 1 |
| 0 | 2D8 |
0 | 1 |
| 1 | 2E8 (COM4) |
1 | 0 |
| 0 | 2F8 (COM2) |
1 | 0 |
| 1 | 3D8 |
1 | 1 |
| 0 | 3E8 (COM3) |
1 | 1 |
| 1 | 3F8 (COM1) |
.
%-
+
,- 
This table is also printed on the board.
The IRQ used for the modem is set in section IRQ_A. Place one jumper in this section to select an IRQ number in the interval IRQ3 to IRQ15.
SIM card
The SIM card connector (CN9) is placed on the rear side of the module. A SIM card must be placed in this connector in order to establish a wireless communication.
Modem AUX connector CN3
The modem has a
•Four digital inputs
•Three
•One
The table shows the connector layout:
Pin no Name
Signal name in modem Pin no CDB-9F
1 | GND |
|
2 | DAC | DAC |
3 | ADC #3 | ADC3 |
4 | ADC #2 | ADC2 |
5 | ADC #1 | ADC1 |
6 | Digital input #4 | IO4 |
7 | Digital input #3 | IO3 |
8 | Digital input #2 | IO2 |
9 | Digital input #1 | IO1 |
10 | NC |
|
1
6
2
7
3
8
4
9
5
The protection circuitry between the modem and CN3 is shown here.
(
<
%0
&'&*/?**/'&)$
(
8
These I/Os are operated by AT commands in the modem.
Page 7 / 19