Page 426 of 456 Installing a Signaling Server
19Remove the Signaling Server Software CD or the Signaling Server Software CF Card (as appropriate) from the RMD drive of the Signaling Server and enter q to close/terminate the Installation Tool and reboot the system. The following system messages appear:
Removing temporary file "/u/disk.sys".
Rebooting system ....
End of Procedure
First boot of a new Nortel CP PM Signaling Server
Nortel CP PM Signaling Servers have CS 1000 Release 5.5 software, applications, operating system, and web files preloaded on the hard drive when they are shipped. On the first boot of a Nortel CP PM Signaling Server, the Signaling Server Software Installation Tool prompts you to enter basic system configuration parameters.
Before you begin
Before booting the new Nortel CP PM Signaling Server for the first time and entering basic system configuration parameters, you must perform the following tasks:
•Install and connect the Signaling Server (refer to “Installing the CP PM Signaling Server hardware” on page 387).
•Obtain the network and IP Telephony data for the Signaling Server from your Planning and Engineering group:
–node ID for the IP Telephony node
–node IP address for the IP Telephony node
–hostname for the Signaling Server
–ELAN network interface IP address, Subnet mask, and Gateway
–TLAN network interface IP address, Subnet mask, and Gateway
–ELAN network interface IP address of the Call Server
