Nortel Networks 1000M Verifying a successful configuration, Testing the Leader Signaling Server

Installing a Signaling Server Page 447 of 456

Verifying a successful configuration

To ensure that the Signaling Server Ethernet connections (for the ELAN and TLAN subnets) are configured correctly, perform a ping test to one or more of the other devices connected to the network, particularly the Call Server.

Procedure 82

Verifying the Signaling Server Ethernet connection

1Log in to the Signaling Server, using Procedure 81 on page 446.

2Ping the IP address of the Signaling Server. Enter the command: ping x.x.x.x

Where x.x.x.x is the Signaling Server ELAN network interface IP address.

3Ping the IP address of the Call Server. Enter the command: ping x.x.x.x,3

Where x.x.x.x is the Call Server ELAN network interface IP address.

4If desired, repeat step 3 for other devices connected to the network.

End of Procedure

Testing the Leader Signaling Server

Configure two IP Phones to register to the Signaling Server on its temporary node. These IP Phones must be provisioned on the Call Server. Refer to Communication Server 1000E: Installation and Commissioning (NN43041-310), Communication Server 1000M and Meridian 1:

Large System Installation and Commissioning (NN43021-310), or Communication Server 1000M and Meridian 1: Small System Installation and Configuration (NN43011-310) for the procedure appropriate to the system. After provisioning, the telephones can call each other.

Communication Server 1000M and Meridian 1 Large System Installation and Commissioning