76

Page 71 of 456

Positioning and leveling equipment

Contents

This section contains information on the following topic:

Positioning and leveling the equipment

71

Positioning and leveling the equipment

Columns normally stand on adjustable feet that provide leveling capability and ground isolation. However, casters are available and can be used for two-tier columns. If a third module is added to a column with casters, the casters must be replaced with leveling feet.

Note: If earthquake bracing is required, go to “Installing earthquake bracing” on page 343 to install column and floor bracing, and to position and level equipment. When those procedures are complete, return to Step 4 or Step 5 (as applicable) in the initial installation procedure.

Use Procedure 3 to position and level the equipment.

Procedure 3

Positioning and leveling the equipment

1Check the equipment room floor plan to position columns.

2Level the column.

a.Remove the front and rear exhaust grills.

b.Remove the front and rear air intake grills.

Communication Server 1000M and Meridian 1 Large System Installation and Commissioning

Page 71
Image 71
Nortel Networks 1000M warranty Positioning and leveling equipment, Positioning and leveling the equipment