Nortel Networks 1000M warranty Leader/Follower Signaling Server configuration

Installing a Signaling Server Page 429 of 456

4Enter the location (loop and shelf) of the IPMG board.

Note: If the IPMG has not been configured yet, the loop and shelf information can be left at the current value. The IPMG board location can be updated using OAM shell commands after the Signaling Server is configured.

5The Leader/Follower configuration screen appears (Figure 175).

Figure 175

Leader/Follower Signaling Server configuration

CS 1000 Signaling Server Software Install Tool (sse-x.xx.xx)

=====================================================================

Note: This step will over-write all existing configuration parameters on this Signaling Server.

Please select the role of this Signaling Server.

If this Signaling Server will be a Leader then its data networking and IP Telephony parameters must be entered now. (This will pre- configure the IP Telephony node files.)

If this Signaling Server will be a Follower then its data networking and IP Telephony parameters must be configured through Element Manager later.

Please enter:

<CR> -> <a> - Set this Signaling Server as a Leader. <b> - Set this Signaling Server as a Follower. <q> - Quit.

Enter Choice>

6Configure the Signaling Server as a Leader or Follower. If there is already a Leader Signaling Server in the IP Telephony node, enter b at the prompt to configure this Signaling Server as Follower. The Follower Signaling Server configuration screen appears (Figure 176). Go to step 15 on page 421.

Communication Server 1000M and Meridian 1 Large System Installation and Commissioning